Toshiba RD-XV48KE Basic Setup, Initial Setting, Channel Setting, Auto Tuning, Manual Tuning

E3LG0ED_EN.book Page 22 Wednesday, April 30, 2008 11:52 AM

Basic Setup

Initial Setting

When you turn on this unit for the first time, you need to follow these steps.

1 Press [B ON\STANDBY].

2 Turn the TV on. Select the input to which the unit is connected.

“Initial Setting” will automatically appear.

3 Select your desired language for the OSD using [U \ D]. Then press [ENTER] to go to the next step.

Initial Setting

OSD Language

English

Français

Español

Deutsch

Italiano

Svenska

Nederlands

4 Press [ENTER] to start Channel Tuning.

The unit will start getting channels available in your area.

Initial Setting

Auto Tuning

Make sure the antenna is connected to “ANTENNA IN” jack.

Start

5 After finished channel setting, “Clock Setting” will appear. Then press [ENTER].

Initial Setting

Clock Setting

-- / - - / - - - - ( - - - )

-- : - -

6 Follow to step 5 on page 25 in “Manual Clock Setting”.

Channel Setting

Tuning of this unit to broadcast channels can be performed in two ways.

Auto Tuning

Programme the tuner to scan only the channels you can receive in your area.

1 In stop mode, press [SETUP]. Select “General Setting” using [U \ D], then press [ENTER].

2 Select “Channel” using [U \ D], then press [ENTER].

3 Select “Auto Tuning” using [U \ D], then press [ENTER].

The unit will start storing channels available in your area.

General Setting
Playback	Auto Tuning
Display
Video	Manual Tuning
Recording	Move
Clock
Channel
DivX
HDMI
Reset All

Wait for several minutes to finish channel storing.

4 Press [SETUP] to exit.

You can select only the channels memorised in this unit by using [PROG. G \ H].

To cancel auto tuning

Press [RETURN] or [SETUP] during scanning.

Note

•The selection will be affected by how you receive TV channels in your local area.

•If the auto tuning is cancelled during scanning, some channels not yet tuned may not be received.

•You cannot change the channel when this unit is in any recording mode (normal recording, One-touch Timer Recording or timer recording).

Manual Tuning

Manually tune each channel.

1 In stop mode, press [SETUP]. Select “General Setting” using [U \ D], then press [ENTER].

2 Select “Channel” using [U \ D], then press [ENTER].

22 EN