Toshiba RD-XV48KE Setting the Clock, Auto Clock Setting, Manual Clock Setting, Press Enter again

Press [B ON\STANDBY] to turn the unit off.

E3LG0ED_EN.book Page 25 Wednesday, April 30, 2008 11:52 AM

Setting the Clock

Auto Clock Setting

This unit receives time signals from the channels, and sets the clock automatically. Set the channel tuning before setting Auto Clock.

1 In stop mode, press [SETUP]. Select “General Setting” using [U \ D], then press [ENTER].

2 Select “Clock” using [U \ D], then press [ENTER].

General Setting

Playback

Display

Video

Recording

Clock

Channel

DivX

HDMI

Reset All

3 Select “Auto Clock Setting” using [U \ D], then press [ENTER].

4 Select “ON” using [U \ D], then press [ENTER].

5 Press [SETUP] to exit.

6

•The Auto clock function is activated.

•This unit will search for the time every time when the power is turned off.

•Leave the unit off for about 10 seconds to give it time to set the clock.

Hint

•If you want to cancel “Auto Clock Setting”, select “OFF” using [U \ D], and then press [ENTER] at step 4.

Note

•The default setting of “Auto Clock Setting” is “ON”.

•The clock may set itself automatically after you connect the antenna cable to the unit and plug in the mains cable. In this case, the current time will appear on the front panel display.

•To set the clock automatically, the channel assigned to “P01” must receive the PDC signal.

•The clock cannot be set automatically if you are not receiving a channel in your area that carries a time signal. In this case, set the clock manually.

•Once the auto clock setting is performed, the unit will correct the current time by receiving PDC broadcasts whenever the unit is in standby mode.

•The unit will correct the current time automatically at 8:00 and 1:10, if the unit is in standby mode.

•Between 23:00 and 1:00, the Auto Clock function will not operate even when the unit is in standby mode.

Manual Clock Setting

1 In stop mode, press [SETUP]. Select “General Setting” using [U \ D], then press [ENTER].

2 Select “Clock” using [U \ D], then press [ENTER].

3 Select “Clock Setting” using [U \ D], then press [ENTER].

Default date will appear.

4 Press [ENTER] again.

Clock Setting

01	/ 01 / 2008	(TUE)
		0 : 00

5 Enter the date (day / month / year) using [U \ D].

Press [P] to move the cursor to the next field. If you want to go back to the previous field, press [L].

6 Enter the time (hours / minutes) using [U \ D], then press [ENTER].

The clock will start.

•Although seconds are not displayed, they will be counted from zero.

7 Press [SETUP] to exit.

Note

•Your clock setting will be lost if either there is a power failure or the unit is unplugged for more than 30 seconds.

EN 25

Introduction Connections Basic Setup Recording Playback Editing Function Setup VCR Functions Others