Toshiba SATELLITE PRO A120, Tecra A8 manual USB device, Bios Beep Sounds

Troubleshooting

Fingerprint Sensor

Problem	Procedure
Reading of the	Try again using the correct posture. Align your
fingerprint was not	fingertip with the sensor as shown in the drawing
successful.	and Swipe. Refer to Using the Fingerprint Sensor
	in Chapter 4, Operating Basics.Try the
	recognition process again using another enrolled
	finger.

The fingerprint cannot be read due to injuries to the finger.

Try the recognition process again using another enrolled finger.

If fingerprints from all the enrolled fingers cannot be read, please logon by using the keyboard to input the password for the time being.

If problems persist, contact your dealer.

USB device

Refer also to your USB device’s documentation.

	Problem	Procedure
	USB device does not	Check for a firm cable connection between the
	work	USB ports on the computer and the USB device.
		Make sure the USB device drivers are properly
		installed. Refer to your Windows XP
		documentation for information on checking the
		drivers.
		If you are using an operating system that does
		not support USB, you can still use a USB mouse
		and/or USB keyboard. If these devices do not
		work, make sure the USB KB/Mouse Legacy
		Emulation item in HW Setup is set to Enabled.
		If problems persist, contact your dealer.
Bios Beep Sounds
	Problem	Procedure
	Beep sounds	Beep volume can be set to High/Medium/Low/Off
		using the Bios Setup Program. The Default is
		Medium.
		The volume for the loud beep sound that occurs
		when there is a memory error cannot be
		adjusted.

9-16 User’s Manual