3-8 User’s Manual
Getting Started

Standby limitations

Standby will not function under the following conditions:
■Power is turned back on immediately after shutting down.
■Memory circuits are exposed to static electricity or electrical noise.
Hibernation Mode
The Hibernation Mode feature saves the contents of memory to the hard
disk when the computer is turned off. The next time the computer is turned
on, the previous state is restored. The Hibernation Mode feature does not
save the status of any peripheral devices.

Benefits of Hibernation Mode

The Hibernation Mode feature provides the following benefits:
■Saves data to the hard disk when the computer automatically shuts
down because of a low battery.
■You can return to your previous working environment immediately when
you turn on the computer.
■Saves power by shutting down the system when the computer receives
no input or hardware access for the duration set by the System
hibernate feature.
■You can use the panel power off feature.

Starting Hibernation Mode

To enter Hibernation Mode, follow the steps below.
1. Click start.
2. Select Turn Off Computer.
3. Open the Turn Off Computer dialog box.
■Save your data. While entering Hibernation Mode, the computer saves
the contents of memory to the hard disk drive. However, for safety
sake, it is best to save your data manually.
■Data will be lost if you remove the battery or disconnect the AC adaptor
before the save is completed. Wait for the HDD indicator to go out.
■Do not install or remove a memory module while the computer is in
Hibernation Mode. Data will be lost.
For the computer to shut down in Hibernation Mode, this feature must be
enabled in two places: the Hibernate tab in Power Options and Setup
Actions tab in TOSHIBA Power Saver.
If you do not configure this feature, the computer will shut down in Standby
Mode - if battery power becomes depleted, data saved in Standby Mode
will be lost.
You can also enable Hibernation Mode by pressing Fn + F4. Refer to
Chapter 5, The Keyboard, for details.