Toshiba SL-9000-ESB SERIES Transferring Logo Data, Error message during data transmission

11. PROGRAMMING PROCEDURES

11.16 TRANSFERRING LOGO DATA

11.16 TRANSFERRING LOGO DATA

In ESB Limited Spec. Mode, this programming is unavailable.

Menu Group: 2

Item No.:8

Logo data is created on a PC and stored into RAM through the CMT interface. Two different sizes of logos, 320x118 dots and 256x64 dots, are available on the SL-9000 series. 64KB of RAM area is secured for logo data, in which the maximum of 13 logos (320x118 dots) or 26 logos (256x64 dots) can be stored. Before starting the following operation, set the initial setting #10-7 to 1.

<MENU>

Group 2

				Select a transmission item.
8	Load the tape into			1: SAVE(SL-9000	CMT)
		the CMT Loader		2:VERIFY(SL-9000=CMT)
				3:LOAD(SL-9000	CMT)
	ENTER	PROG. <MENU>
			Group 2
		ESC.	Main
			<MENU>

NOTE: Two sizes of logos are printed differently as follows:

<Label><Receipt>

320x118-dot size logo

256x64-dot size logo

The logo is printed at the lower	A whole Logo #1 and a half of
center of the print area.	logo #2 area printed.

: Print area for logo

: Logo

Table 6: Error message during data transmission

	Error position
Error message	Cause
	Header text Data text
TIME OUT ERROR	Timeout
	Incorrect segment
	Incorrect logo size
	Incorrect number of logos
DATA ERROR	Incorrect logo number
	Incorrect number of dots to be printed.
	Parity error
	Framing error
	Overrun error

11-28