Toshiba SL-9000-FFH-CA Operating Procedures, How to access REG., M.DOWN, or REWRAP menu

13- 1

SET NEXT

13. OPERATING PROCEDURES

■ NOTES BEFORE STARTING OPERATION

13. OPERATING PROCEDURES

WARNING!

Do not exceed the platter weight of maximum capacity. Or hang any item from the scale which exceed the platter weight.

■NOTES BEFORE STARTING OPERATION

(1)	Turn the power ON.
(2)	A sixteen-second scanning will be performed after pressing the	POWER	key.

(3)Should a power failure occur during operation, remove the commodity from the platter and insert the power plug into an AC outlet again when power is restored.

(4)If the scale is used with an unrated power source, inaccurate scaling or other errors may occur.

(5)If the zero point has shifted during scaling, and no tare is displayed, adjust the zero point by depressing the ZERO key.

(6)Check the date of the scale before operation every day.

(7)Make a test print before operation every day. Press the TEST key, and the test label is issued.

■How to access REG., M.DOWN, or REWRAP menu

The following display is the REG. menu display. When this display is shown after pressing the POWER key, you can start the REG. operation right away.

<REG.> MANU. WEIGH ENTER THE PLU #

lb	UNIT/$	TOTAL $
0.000	P	000000

To access a menu from other menus, press the ESC. key to show the Main menu and enter the menu No. When the M.DOWN and REWRAP menus are protected, enter the menu No. and then the password.

<Menu>
0.	PROG.	5.	REPORT
1.	REG.	6.	RESET
2.	MARK DOWN	7.
3.	REWRAP	8.
4.	SECURITY	9.

NOTE: If a label nothing is printed on is Section 10.11 and press the

issued after a printed label in batch mode, refer to key.