Toshiba SL-9000N-FFH-CA, EM1-31076 Error Message Table, CMT Operation Mode, Cause, Solution, Bm/S

15. ERROR MESSAGE TABLE

15. ERROR MESSAGE TABLE

●

CMT Operation Mode

Message

Cause

Solution

Mismatch of the model type.

Mismatch of the base unit.

MISMATCH SCALE SPEC

Press the

key

Mismatch of the VERSION.

CLEAR

Mismatch of the

TRANSMITTING DATA.

Mismatch of the scale capacity.

Parity error

Framing error

BAD TAPE OR CMT

Press the

key

Overrun error

CLEAR

Data error

Two or More Hardware error

TIME OUT ERROR

Time out error

Press the

CLEAR

key.

●

LON System Mode

Message

Cause

Solution

M

BM/S

COMMUNICATION

1. The power of the master or

1. Turn the power of the master

ERROR

backup master scale is not turned

or backup master scale ON.

ON.

Connect them with each other

They are not connected with each

or turn the scale in-line.

○

○

other or in off-line state.

2. Call your authorized service

2. LON cable is broken.

representative.

SEQUENCE ERROR

The power was not turned OFF and

Turn the power switch OFF and

○

○

ON again after setting ID #.

ON again.

SEQUENCE NO.

Text data number is incorrect.

Call your authorized service

―

○

ERROR

representative.

MASTER BUSY

Registration job is performed on a

1. Quit reset job on the master

satellite scale while reset job is

scale.

―

○

performed on the master scale.

2. Quit registration job on the

satellite scale.

BACKUP MASTER

The backup master does not have

Down load PLU from the master

NOT RESET

same PLU with the master scale.

to the backup master scale.

○

―

Then run the reset operation

again.

TEXT ERROR ##

1. Error text is found.

Call your authorized service

02:

Sequence No. error

representative.

05:

LRC error

08:

Text error

○

○

09:

Command error

2. The

master scale differs from

other scale in ROM version.

M: Master scale BM: Backup master scale S:

Satellite scale

15- 3