Toshiba SL-9000N-FFH-US, SL-9000N-FFH-CA, SL-9000N-FFH-QR, SL-9000-FFH-US Cleaning The Print Head

Screw (FL-3x6)

16. CLEANING THE PRIT HEAD

16. CLEANING THE PRINT HEAD

16. CLEANING THE PRINT HEAD

WARNING!

Care must be taken not to injure your fingers with the label cutter during installing, removing or cleaning it.

If the print head is dirty, printing will not be clear. The print head should be cleared with a print head cleaner everyday before use, according to the following procedure:

1.Open the printer cover and turn the head-up lever to the anticlock wise. (See page 8-1)

2.Clean the print head element with the print head cleaner.

NOTE: Be careful not to damage the print head when cleaning.

Print Head Element

Print Head Cleaner

3.If any label paste is found on the label cutter, wipe off the paste with alcohol.

■After removing the label cutter, reattach it using the following procedure.

1.Remove the receipt/label from the scale.

2.Install the label cutter, aligning the cutter notches with the screw holes.

3.Secure the cutter with the screws (FL-3×6) so the bottom of the cutter is 0.5～0.8 mm above

the peel-off plate.

Screw (FL-3x6)
Clearance
0.5～0.8 mm	Label Cutter
Strip Plate	Label Cutter

NOTES:

1.If the cutter is scratching labels during printing, increase the clearance between the cutter and the peel-off plate.

2.When the cutter is stained with glue or paper dust, clean it with a cotton swab moistened with alcohol.

16- 1