Toshiba EM1-31076EE, SL-9000N-FFH-CA Weighing Operation, Menu REG., M.DOWN, or REWRAP Mode WEIGH

13. OPERATING PROCEDURES

13.1 WEIGHING OPERATION

13.1 WEIGHING OPERATION

Menu: REG., M.DOWN, or REWRAP

Mode: WEIGH

The weigh mode is used to weigh a commodity and to issue the label. The label contains data such as a weight, unit price (price per weight) and total price (calculated as a result of the weighing operation). The following is a basic operation seen at the sales floor of a store or at a back room where different kinds and weights of commodities are repacked. Pressing the [VOID] key subtracts the last entry from the memory.

Example) When PLU #100 and an unit price of $8.00 are set in the speed key #12.

Enter the PLU #. 1 0 0

Press : PLU

LB

kg

Press the	12
speed key.

The unit of measure can be changed for CA/QR model only.

LB Ö kg

Available only when the initial setting # 5-6 is set to 1.

lb scale

kg scale

100 g 1/4 1/2

Place a commodity on the platter.

(Ex. 1.000 lb.)

MANUAL :	:	AUTO
	*

The label is issued

Press when canceling	VOID
the last sales.

<REG.> MANU. WEIGH

T-BONE STEAK

lb	UNIT/$	TOTAL $
1.000	8.00	8.00

TEC STORE

(TEL) 0123-45-6789

(Sample label)

NOTES:

1.Pressing a speed key to which no PLU data has been assigned will result in an error. In this case, press the C key, then press a speed key to which PLU data has been assigned.

2.To change between AUTO and MANUAL, follow the procedure provided in section 13.9.

3.If a unit price exceeding 4 digits is obtained by multiplying by 2 or 4 (when pressing the 1/2 lb key or 1/4 lb key), the unit price will be 0.

4.100 g key is available only when the scale is a kg scale or operated on kg base.

5. When the 1/2 lb , 1/4 lb or 100 g key is pressed, the unit price does change on the display.

6.When the “compulsory tare” is selected, a tare must be subtracted in a weighing operation, otherwise an error message “TARE REQUIRED” will be displayed when the following operation has been done:

① Manual mode: Pressing the PRT/* key.

②Auto mode: Placing a commodity on the platter.

③ Floating vendor mode: Pressing the Vendor key.

When a “TARE REQUIRED” is displayed, refer to Section 13.6 to follow the proper weighing procedure.

13- 2