TL-WA901ND 300Mbps Wireless N Access Point User Guide
2.Configure the Switch.
Enable 802.1Q Tag VLAN function on the switch.
Make sure the Untag frames are forwarded.
The following table shows the detailed configuration for the switch
Port | VLAN ID |
| PVID | Egress Rule | Processing mode of Utag |
| Frames | ||||
|
|
|
|
| |
1 | 1 |
| 1 | Untag | Forwarding |
|
|
|
|
|
|
2 | 2 |
| 2 | Untag | Forwarding |
|
|
|
|
|
|
3 | 3 |
| 3 | Untag | Forwarding |
|
|
|
|
|
|
4 | 4 |
| 4 | Untag | Forwarding |
|
|
|
|
|
|
5 | Port5 belongs to | all | 1 | Tag | Forwarding |
| VLANs |
|
|
|
|
|
| Table | |||
Connect PC1, PC2, PC3 and PC4 to port1, port2, port3 and port4 of the switch respectively. The corresponding VLAN IDs of the four ports are 1, 2, 3 and 4.
Configure port5 of the switch to be the member of VLAN1, VLAN2, VLAN3 and VLAN4 and connect it to the LAN port of
Configure the VLAN ID of the PC that can log on to the Web management page of
3.Verify the communication status after the above configuration is completed.
If VLAN ID of the PC connected to the switch is different from the VLAN ID of the wireless STA, the two cannot communicate with each other, for example, PC1 and STA2.
If the PC connected to the switch and the wireless STA have the same VLAN ID, the two can communicate with each other, for example PC2 and STA2.
32
