TP-Link TL-WA901ND manual Rear Panel,  Used as Reset button

TL-WA901ND300Mbps Wireless N Access Point User Guide

1.4.2 The Rear Panel

Figure 1-2

Viewed from left to right, the following parts are located on the rear panel of TL-WA901ND. ON/OFF: The switch for the power.

POWER: The power port connects to the power adapter provided with the TL-WA901ND 300Mbps Wireless N Access Point.

Ethernet: One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or a router.

WPS/RESET: This button is used for both WPS and Reset function. To use the WPS function, press it for less than five seconds; to use the RESET function, press it for more than five seconds.

Used as RESET button:

There are two ways to reset to the Router's factory defaults:

1)Use the Factory Defaults function on System Tools ->Factory Defaults page in the Router's Web-based Utility.

2)Use the WPS/RESET button: With the Router powered on, press and hold the WPS/RESET button (more than 5 seconds) until the SYS LED becomes quick-flash from slow-flash. Then release the button and wait the Access Point to reboot to its factory default settings.

4