TP-Link TL-WA901ND manual Wireless Settings in Repeater mode

TL-WA901ND300Mbps Wireless N Access Point User Guide

Note:

To apply any settings you have altered on the page, please click the Save button, and then you will be reminded to reboot the device.

4)WDS Repeater: In WDS Repeater mode, the AP with WDS enabled will relay data to an associated root AP. AP function is enabled meanwhile. The wireless repeater relays signal between its stations and the root AP for greater wireless range.

Figure 4-13 Wireless Settings in Repeater mode

Wireless Name of Root AP - If you select the radio button before Wireless Name of Root AP, the AP client will connect to the AP according to SSID. Enter the SSID of AP that you want to access.

MAC Address of Root AP - If you select the radio button before MAC Address of Root AP, the AP client will connect to the AP according MAC address. Enter the MAC address of AP that you want to access.

Region - Select your region from the pull-down list. This field specifies the region where the wireless function of the device can be used. It may be illegal to use the wireless function of the device in a region other than one of those specified in this field. If your country or region is not listed, please contact your local government agency for assistance.

Note:

Limited by local law regulations, version for North America does not have region selection option.

Channel - Determines the operating frequency to be used. It is not necessary to change the wireless channel unless you notice interference problems with another nearby access point.

Mode - Select the desired wireless mode. The options are:

•11b only - Only 802.11b wireless stations can connect to the device.

•11g only - Only 802.11g wireless stations can connect to the device.

34