maintenance

Maintenance procedures

Adjusting BeltTension

NOTICE

Do not over-tension belts. Exces- sive belt tension will reduce fan and motor bearing life, accelerate belt wear, and possibly cause shaft failure.

To adjust belt tension refer to Figure M- MP-6 and perform the following procedure:

1. Loosen bolts A, B, and E on both sides of the sliding motor base. See Figure M- MP-7.

2. Loosen nuts C and D (as required for motor horsepower) to slide the motor on its mounting plate in the proper direction to tension or relieve tension on

the belt.

Figure O-M-5. Fan assembly.

 

3. Adjust nuts A-D and bolt E. Do not

 

stretch the belts over the sheaves.

 

4. Retighten all nuts and bolts.

 

5.Verify tension is adjusted properly.

 

Recommended belt tension range values

 

are on the unit fan scroll.To access the

 

fan scroll, face the right-hand side of the

 

unit and remove the top left panel. The

 

belt tension label is on the top right-hand

 

corner of the fan scroll. See Figures O-M-

 

8 and O-M-9.

 

The correct operation tension for aV-belt

 

drive is the lowest tension at which the

 

belt will not slip under the peak load

 

conditions. It may be necessary to

 

increase the tension of some drives to

 

reduce flopping or excessive startup

 

squealing.

 

Figure M-MP-7. Belt tensioning with fan adjustment points

Figure M-MP-8. Location of fan belt label on fan scroll

SCXG-SVX01B-EN

97

Page 97
Image 97
Trane SCXG-SVX01B-EN manual Adjusting BeltTension

SCXG-SVX01B-EN specifications

The Trane SCXG-SVX01B-EN is an advanced variable refrigerant flow (VRF) system designed to provide efficient and flexible heating and cooling solutions for commercial and residential applications. This system exemplifies Trane's commitment to innovation, energy efficiency, and ease of installation, making it a standout choice in the industry.

One of the main features of the SCXG-SVX01B-EN is its ability to deliver precise temperature control across multiple zones. The system utilizes a modular design that allows for the connection of multiple indoor units to a single outdoor unit, enabling simultaneous heating and cooling in different areas of a building. This zoned comfort not only enhances occupant satisfaction but also contributes to energy savings by allowing for targeted climate control where it is most needed.

Trane's VRF technology is complemented by its inverter-driven compressors, which adjust their speed according to the demand for heating or cooling. This means that the system operates more efficiently than traditional systems by consuming less energy during partial load conditions. The SCXG-SVX01B-EN also integrates advanced heat recovery capabilities, allowing it to transfer heat from one zone to another, further optimizing energy usage.

The unit's compact design simplifies installation, making it suitable for both retrofit projects and new constructions. The flexible piping layout supports various configurations, allowing easy adaptation to the building's architecture. The model also incorporates intelligent controls, offering a user-friendly interface that enhances operational flexibility and promotes energy management.

In addition to its performance features, the Trane SCXG-SVX01B-EN emphasizes sustainability. It uses advanced refrigerants with low global warming potential (GWP), aligning with environmental regulations and helping to minimize the system's ecological footprint. The durable construction of the system ensures longevity and reliability, reducing maintenance costs and enhancing overall operational efficiency.

Finally, Trane supports its products with comprehensive warranties and a network of service professionals, ensuring that customers have access to expert assistance throughout the life cycle of their system. The SCXG-SVX01B-EN represents a blend of technology, efficiency, and versatility, making it an ideal choice for those seeking an effective heating and cooling solution.