Traulsen R & A Series owner manual VII. e Notes to the User

VII. INTELA-TRAUL®(continued)

VII. e - NOTES TO THE USER:

You only have 20-30 seconds between button pushes. If you take longer than 30 seconds, the controller will revert back to displaying the cabinet temperature. If you enter the wrong security code, the controller will revert back to displaying the cabinet temperature. You can exit the parameters at any time by pressing the alarm cancel button or by waiting 20-30 seconds.

VII. f - ENTER THE CUSTOMER ACCESS: This is required to set any of the control parameters

Use the security code 0, A, 1				and the following instructions:
Press the set button	SET .	The display will read			Customer/Service Access.
Press the set button	SET .
The display will show three zeros with the left zero flashing
Press the set button	SET .
The display will show three zeros with the center zero flashing
Press the down arrow key			to sequence through F, E, d, C, b, A, 9, 8, 7,…etc.
When you reach A press set SET .
The display will show zero, A, zero with the right zero flashing						.
Press the up arrow key		to sequence through 1, 2, 3, 4, 5, 6, 7, 8, 9, A, b,…etc.
When you reach 1 press set		SET .
The display will read		Thermostat Set Point High.

You are now in the CUSTOMER / SERVICE PARAMETERS.

-11-