7. Detailed Description
To start MultiTemp III in 8 mode ON, follow the instructions below:
1.Check that all tubings are firmly connected and secured with hose clamps.
2.Switch the power on with the mains switch.
The display flashes
.
3.Press 
for start.
The version number of the software is briefly shown on the display. The pump motor and compressor start up, liquid starts to circulate, and the heater will be activated if the set temperature is greater than the actual temperature.
Add more liquid if necessary, until the level is 2 cm below the top plate and proceed as described under Section 4.2, Setting the temperature limit.
Resetting mode 8 to OFF
Change to mode 8 OFF with the following procedure.
1.Press 
simultaneously with the main switch.
The display flashes |
|
|
|
|
|
| . |
|
|
|
|
|
|
|
|
2.Press 
.
3.Press 
select “mode 8”.
4.Press 
to select “OFF”.
5. | Confirm by pressing | when the display is flas- |
| hing. |
|
6.Wait until the display shows the actual temperature.
7.Switch off the unit using the mains switch.
The operation mode is now changed to OFF.
To start MultiTemp III in 8 mode OFF, follow the instruc- tions described in Section 4.1,
21
