Manuals / TRENDnet / Computer Equipment / Network Card

TRENDnet 18-1106-33 user manual Ordering information, Designation, Code No, Accessories, Quantity

Models: 18-1106-33

1 27

Download 27 pages 29.55 Kb

Page 25

9. Ordering information

9. Ordering information

9. Ordering information

Designation		Code No.
MultiTemp III 100-120 V		18-1102-77
MultiTemp III 220-240 V		18-1102-78

Accessories

Item	Quantity	Code No.
Cooling Tubing, 8/12 mm, silicone	4 m	80-1106-56
Tubing Connector Set female and male	4	18-1104-26
Hose clamps	10	18-1104-27
Insulation for cooling tubing 14/27 mm	8 m	80-1116-11
3-way Valve Set	1	18-1106-39

23

Image 25

TRENDnet 18-1106-33 user manual Ordering information, Designation, Code No, Accessories, Quantity

Contents

P H A R M A C I A B I O T E C H MultiTemp User Manual18-1106-33 Edition AD Important user information Warranty and LiabilityCopyright 1997 Pharmacia Biotech AB Contents Page 2.1 Safety precau- tions 2. Safety information1. Introduction 2.2 Safety standards Restart after power failure 2.3 Safety featuresGeneral cut-off Protection against over-heating3.1 Unpacking and installation 3. Installation3.4 Filling and draining the bath 3.2. Tubing connec- tions 3.3 Recom- mended bath liquids3.5 Mains connection 4.1 Start-up 4. Operation4.2 Setting the temperature limit 4.3 Tempera- ture setting limit 4.4 Tempera- ture setting 4.5 Tempera- ture correction value has been pres Note The new value is not saved until4. Operation 5.1 Error messages 5. Trouble shooting5. Trouble shooting The bath temperature has exceeded6.1 General 6. MaintenanceDisposal PUSH 7.1 General operating principle 7.2 Front and rear panels 7. Detailed Description7.3 Control panel Actual temperature mode shows the actual temperature in the bath General cut-off 7.4 Description of safety featuresProtection against over-heating Protecting the pump motor Accurate Setting of Temperature Limit1. Set the temperature limit switch to its highest value Sensor check7.5 Manual restart in operation mode Setting mode 8 to ONRestart after power failure The unit can be restarted manually instead by pressing see SectionResetting mode 8 to OFF Technical specifications ambient temperature 20 C 8. Technical specificationsAccessories 9. Ordering informationDesignation Code NoPage Short instructions