Short instructions
Note: The following short instructions are intended as a guide to users who are fully familiar with safety procedures and operating instructions described earlier in this manual.
1.Check to make sure that all tubings are firmly connected and secured with hose clamps.
2.Check the liquid level and fill the bath if needed (the level should be
3.Switch the power on at the mains switch.
4.Set the safety temperature limit using the dial on the rear of the unit.
5.Set the setting range limit of the circulator (if required by the application or any safety precautions).
6. Set the working temperature. Press 
to select the S mode
.
Use 
or 
to set the working temperature. Confirm with
before the display automatically returns to the actual working temperature.
7.Set the temperature correction value if required.
A
Printed in Sweden by TK i Uppsala, July 1997
