TRENDnet User’s Guide
1.Log into your router management page (see “Access your router management page” on page 24).
2.Click on Main, and click on WAN.
3.Under your Internet connection settings, find the MAC Address section shown below.
4.Select Enabled in the pull down menu and manually enter the
5.To save changes, click Apply.
Change your router IP address
Network > LAN Setting
In most cases, you do not need to change your router IP address settings. Typically, the router IP address settings only needs to be changed, if you plan to use another router in your network with the same IP address settings, if you are connecting your router to an existing network that is already using the IP address settings your router is using, or if you are experiencing problems establishing VPN connections to your office network through your router.
Note: If you are not encountering any issues or are not faced with one of the cases described above or similar, it is recommended to keep your router IP address settings as default.
Default Router IP Address: 192.168.10.1
Default Router Network: 192.168.10.0 / 255.255.255.0
1.Log into your router management page (see “Access your router management page” on page 24).
2.Click on Network, and click on LAN Setting.
TEW-691GR
3.In LAN Interface Setting section enter the router IP address settings.
•IP Address – Enter the new router IP address. (e.g. 192.168.200.1) Subnet Mask – Enter the new router subnet mask. (e.g. 255.255.255.0)
•MAC Address: The MAC address of your router
Note: The DHCP address range will change automatically to your new router IP address settings so you do not have to change the DHCP address range manually to match your new router IP address settings.
4.To save changes, click Apply.
Note: You will need to access your router management page using your new router IP address to access the router management page. (e.g. Instead of using the default http://192.168.10.1 using your new router IP address will use the following format using your new router IP address http://(new.router.ipaddress.here) to access your router management page.
Set up the DHCP server on your router
Network > LAN Setting
Your router can be used as a DHCP (Dynamic Host Configuration Protocol) server to automatically assign an IP address to each computer or device on your network. The DHCP server is enabled by default on your router. If you already have a DHCP server on your network, or if you do not want to use your router as a DHCP server, you can disable this setting. It is recommended to leave this setting enabled.
1.Log into your router management page (see “Access your router management page” on page 24).
2.Click on Network, and click on LAN Setting.
© Copyright 2012 TRENDnet. All Rights Reserved.
27
