TRENDnet User’s Guide |
|
the same dynamic routing protocol and version is also enabled on the other routers in order your router and the other routers to exchange information about the network.
Note: Configuring this feature assumes that you have some general networking knowledge.
1.Log into your router management page (see “Access your router management page” on page 24).
2.Click on Advanced, and click on Routing.
3.Select Enabled in the pull down menu and the appropriate dynamic routing protocol and version communicate with other routers.
•RIP mode: Allows your router to send out network information to other routers so other routers can dynamically build routes to your network.
o RIP 1 - Sends out routing information to other routers using the RIP version 1 protocol.
o RIP 2 – Sends out routing information to other routers using the RIP version 2 protocol (recommended if supported by both devices).
4.Click Apply to save the changes or click Cancel to discard the changes.
Enable Application Level Gateway (ALG)
Advanced > ALG
You may want to setup your router to allow computers to use certain protocols or services on your network. Application Level Gateway or ALG allows you to simply enable or disables these services.
Note: Default all services are enabled.
1.Log into your router management page (see “Access your router management page” on page 24).
2.Click on Advanced, and click on ALG.
3.View and select which service you would like to enable or disable.
•RIP mode: Allows your router to send out network information to other routers so other routers can dynamically build routes to your network.
•Email Receiving (POP3): Allows POP3 protocol to be used through your router
•Email Receiving (SMTP): Allows SMTP protocol to be used through your router
•Streaming Video (RTP): Allows RTP video protocol to be used through your router
•Streaming Media (RTSP): Allows STMP video protocol to be used through your router
•Streaming Media (WMP/MMS): Allows WMP/MMS protocol to be used through your router
•Streaming
•Streaming
•File Transfer (FTP): Allows FTP protocol to be used through your router
•File Transfer (TFTP): Allows TFTP protocol to be used through your router
© Copyright 2012 TRENDnet. All Rights Reserved.
37
