TRENDnet User’s Guide
1.Log into your router management page (see “Access your router management page” on page 27).
2.Click on Routing, and click on Static.
3.Review the static route settings.
•Network Address – Enter the IP network address of the destination network for the route.
(e.g. 192.168.20.0)
•Network Mask – Enter the subnet mask of the destination network for the route.
(e.g. 255.255.255.0)
•Gateway Address – Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)
•Interface – Click the
(e.g. LAN)
•Metric – Enter the metric or priority of the route. The metric range is
•Add – Saves the static route.
To modify an existing reservation, click on the entry in the static route list. When selected, the entry will be highlighted.
•Update – Saves changes to an existing static route.
•Delete – Removes an existing static route.
•Cancel – Discards changes to existing static route.
Enable dynamic routing on your router
Routing > Dynamic
You may want to setup your router to route computers or devices on your network to other local networks through other routers. If other routers support dynamic routing such as RIP (Routing Information Protocol), you can enable this feature on your router to automatically learn the required routes to reach those networks. It is required that the same dynamic routing protocol and version is also enabled on the other routers in order your router and the other routers to exchange information about the network.
Note: Configuring this feature assumes that you have some general networking knowledge.
1.Log into your router management page (see “Access your router management page” on page 27).
2.Click on Routing, and click on Dynamic.
3.Select the appropriate dynamic routing protocol and version communicate with other routers.
© Copyright 2012 TRENDnet. All Rights Reserved.
39
