TRENDnet VoIP Gateway, TVP- 221H manual tvp2.dyndns.org, Local from PC in same Segment, Console

TVP-221H User’s Guide

Dial Plan Settings / Dial plan Table
Setup
11.	Select “Add” and “HuntGroup”
12.	Enter following fields
	a. Hunt Group ID: 22
	b. Destination ID: 22
13.	Click on “OK”	atpm dadd <dest_id> dns
Dial Plan Settings / Dial plan Table		<hostname/port> (eg. 22 dns
Setup		tvp2.dyndns.org)

14.Select “Add” and “Remote_Host_Name”

15.Enter the following fields

a.Destination ID: 22

b.Hostname or IP address

(eg. tvp2.dyndns.org)	atpm done
c. Click on “OK”
	atpm store

Dial Plan Settings / Store Dial Plan

16.Click on “Store”

17.Click on “Yes”

Changes to network settings require rebooting to take effect. Changes to the Dial Plan do not and will take effect as soon as they are stored.

Caution: If you do not store the dial plan, it will be lost when you reboot.

Note: After changing the default IP address, you will be required to use the new IP Address (hostname), in this example tvp1.dyndns.org, to gain access to the TVP-221H via web browser user interface or Telnet.

TVP-221H configuration (cable connection) on site B

Web Configuration	Telnet / Console
Local (from PC in same Segment)
	Console
Open your browser	Connect RS-232 to TVP-221H & PC
3. Enter 192.168.0.1	Open Hyper Terminal
4. You will be prompted for	Input parameters:
Username and Password.	Baud rate	19,200
Default Username and	Number of data bit	8
Password are “admin” and	Parity check	None
“123” respectively.	Number of stop bit	1
	Flow control	None
	Enter “123”
	Local Telnet (from PC in same
	Segment)

59