TRENDnet VoIP Gateway, TVP- 221H manual Task, net set userpw pw pw, Enter ping, Prompt, Type

TVP-221H User’s Guide

The console port uses a DB-9 RS-232 connector. The supplied straight through RS- 232 cable connects the console port of the TVP-221H to a console PC or terminal.

Task

Connect RS-323 Cable to TVP-221H RS-232 console port a your computer that you will use as a configuring terminal

Open HyperTerminal and enter the following Input Parameters when prompted:

When HyperTerminal Screen appears type “123”

In the event that you forget your administration password, you can gain console access to the TVP using the super password. The super password is the last six digits of your MAC address located on the bottom of your TVP (00- 50-2d-xx-xx-xx). At the Console prompt enter the super password without hyphens. The password is all lower case. After gaining access, at the console prompt type in

net set user_pw <pw> <pw>

If entry of new password is successful, the console will list “OK, USER Password Changed”. You will now be able to gain Web Access from a PC in the same local segment using the TVP-221H IP Address (Only applicable if GW and a PC are setup under a router in the same LAN Segment). If Web and / or Telnet Access are enabled, you will also be able to remote access the TVP-224HR by entering http:// followed by the WAN IP or domain name.

When the TVP-221H is directly connected to the ADSL / Cable Modem and remote access to the TVP-221H is not possible because you do not have an second line for Internet Access, it becomes difficult to verify that the TVP-221H has established Internet Access. In order to confirm Internet Access, at the console prompt:

Console>

Enter ping xxx.xxx.xxx.xxx

The following dialogue indicates that Internet Access is successful. (xxx.xxx.xxx.xxx is a know public IP)

Prompt

Baud rate Number of data bit

Parity check Number of stop bit

Flow control

Console>

Type

19,200

8

None

1

None

123

ping xxx.xxx.xxx

85