Error Codes
CARE AND MAINTENANCE
CARE AND MAINTENANCE
Or to indicate an error in speed or incline:
INVALID INCLINE DATA
INVALID SPEED DATA
CALIBRATION ABORTED:
NO SPEED SENSOR
4. Remove and replace Safety Key and exit Calibration Mode
The following Error Codes and Service Codes will follow a double “beep” and show on the display. Service Codes provide preventative maintenance reminders. A Service Code will repeat for the next five times you start the treadmill. A Service Code will clear after any key has been pressed. When an Error Code occurs, call an authorized service technician.
Z7 | DESCRIPTION | |
E1: MINIMUM | Not used | |
| This error occurs when the incline values on the | |
E1:RANGE | display do not match the values stored during calibra- | |
| tion. | |
E1:STALL | This error occurs when the incline motor does not | |
move in response to an incline command. | ||
| ||
E1:INCLINE | This error occurs when the incline motor moved | |
without an incline command. | ||
| ||
E2:OVERSPEED | This error occurs when acceleration exceeded design | |
limits. | ||
| ||
E2:CAL | This error occurs when the speed displayed does not | |
match the stored value from calibration. | ||
| ||
E2:RECAL | This error occurs when a data error is detected at start | |
up. The Control Panel has reset to default values. | ||
| ||
E5:SENSOR | This error occurs when no speed sensor data has been | |
detected at the Control Panel. | ||
|
ERROR AND
SERVICE CODES
62
Z 7 Tr e a d m i l l O w n e r ' s G u i d e
