G B
O W N E R ' S M A N U A L • C 4 0
Push the left footrest support forward so that you can push the adjustment tube in the front of the foot rest support inside the arm tube. Lock the adjustment tube with the locking screw. Repeat the procedure with the right footrest support.
NOTE! The European model allows selecting adjustment (see Adjusting the footrest supports).
METER AND HANDLEBAR
Attach the handle bar into the front frame tube.Withdraw the plastic covers on the screws and thread the hand pulse cords through the opening in the front frame tube. Pull the screws tightly so that the handlebar does not move during the training. Push the plastic covers onto the screws.
Unscrew the two screws in the bottom of the console. Attach the cord from the front tube and the pulse cords to the console outlets. Push the console onto the end of the front tube and fasten the console with the fastening screws. Be careful not to damage the cords!
TRANSFORMER
Before connecting the equipment to a power source, make sure that local voltage matches that indicated on the type plate: the equipment operates at either 230 V or 115 V (North American version). Plug the socket end of the transformer cord into the connector, just above the rear support in the center of the frame, and the other end into the wall socket.
NOTE! The equipment must be connected to a grounded wall socket. Do not use extension wires when connecting the equipment to the power source. Make sure the power cord does not run underneath the equipment.
DANGER: Always switch off the power and unplug this appliance from the electrical outlet immediately after using.
WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons:
5
