O W N E R ' S M A N U A L • F 2 0
SEAT
1.Unscrew the seat support’s locking knob counterclockwise and pull the knob out.
2. Push the seat support in place and tighten with the locking knob clockwise.
3. Attach the seat to the seat support: tighten the locking nuts in opposite directions. Please note that you can adjust both seat inclination and the distance of the seat from the handlebar. Once the distance and inclination are set how you want, tighten the locking nuts carefully.
HANDLEBAR SUPPORT TUBE
1.Remove the 6 washers and screws from the frame tube.
2. Adjust the resistance knob to position 1. Attach
the break wire from the handlebar support tube to the break wire connector in the frame tube.
3. Attach the wires from the frame tube and the handlebar support tube. Push the handlebar support tube into place inside the frame tube.
4. Secure the handlebar support tube with 6 washers and screws.
HANDLEBAR
1.Thread the wire from the handlebar through the hole in the handlebar tube and out through the top of the tube.
2. Install the handlebar. IMPORTANT! The handlebar pin must be aligned with the groove in the socket!
3. Place the socket’s mating piece over the handlebar attachment point and tighten with a fastening screw and two washers through the upper screw hole. IMPORTANT! Do not overtighten the fastening screw: you should be able to adjust the position of the handlebar.
4. Place the plastic cover over the handlebar attachment point.
5.Place two washers and a bushing over the
handlebar fastening screw and tighten fastening screw through the lower hole in the plastic cover. Be careful not to damage the wire!
4
