2.2 Flank Panel |
|
|
1 | 2 | 3 | 4 | 5 | 6 | 7 |
1.Lens Mount: This IP camera is used with either a C or a CS mount lens.
2.DIP Switch:
1.AES: Auto electric shutter.
2.DC IRIS: Use an auto iris (DC drive)
3.DHCP: Turn On / Turn Off to use the DHCP protocol. If the switch points upwards, the device can change the setup of network function (enable/disable) via the network.
4.STATIC IP: If the switch points down, the device can’t obtain an IP address
from the DHCP server. This option is needed to configure the network communication settings.
(*In the default factory configuration, this DIP Switch is in the Down position.)
3.ALARM I/O: This is a
RS485 pin: D+
RS485 pin: D-
GND: Ground Contact.
ALARM IN (INPUT): This is an alarm input which can be programmed in the menu
|
|
| 5V |
|
system to Normally Open or Normally Closed. ( |
| 0V(Active) | ) | |
| ||||
ALARM OUT (OUTPUT): This is an
devices such as buzzers or lights. ( |
|
| 5V | ) |
|
| 0V(Active) | ||
|
|
ALARM RST (RESET): This pin connects to an
alarm. ( |
|
| 5V | ) |
|
| 0V(Active) | ||
|
|
12 | Installation and Operation Guide |
