4.Select 3:TALK GROUP and ID location number by rotating the VFO and pressing E.
5.Select 2:ALPHA TAG by rotating the VFO and pressing E.
M5-0
1216
ENTER ALPHA TAG
6.The cursor appears on the display. Rotate the VFO to
change letters, and press ▲/HOLD or LIMIT/▼ to move right or left. Both capital and lower case letters are available, as well as numbers and punctuation marks.
7.After entering the desired text, press E.
☞ Remember! To clear a mistake while entering the letters, press ▲/HOLD, LIMIT/▼ or | . |
(decimal key) repeatedly until the display is cleared. |
|
Setting the Squelch
For trunked reception, a good setting for the SQUELCH control is in the center of the range with the color marker pointing up. See the illustration.
If it is set too high (CCW) in some cases it could prevent your scanner from locking to the Control Channel reliably. If
it is set too low (CW) it will slightly delay finding the Control Channel. The best setting is the same as for conventional reception, and is not critical.
Receiving Trunked Systems
When you have properly programmed all the frequencies for a trunked system, you can receive the system in several different ways. You will find that Search, Hold, Lockout, Scan and Delay are all similar to conventional scanning.
❖ID SCAN lets you receive those talkgroups that you store in Scan Lists.
❖ID SCAN HOLD lets you selectively listen to a talkgroup in your Scan Lists.
❖TRUNKED SEARCH lets you hear all system talkgroup activity
❖ID SEARCH HOLD works with Search mode to let you quickly freeze reception on an interesting transmission. Or you can manually specify a talkgroup with DIRECT ENTRY in ID HOLD.
❖ID LOCKOUT works with Search and Scan to exclude talkgroups that you don't want to hear.
❖ID DELAY works with each talkgroup to be delayed when the communication ends. The setting periods can be changed (See page 32).
When receiving EDACS systems, remember that Uniden's AFS talkgroups give you powerful flexibility. In a few key presses, you can specify a single talkgroup, a fleet, or an entire agency in all the above modes. Read the section "EDACS Reception" to understand how this works.
Hint: If the scanner is not in the Trunking mode, you can enter the Trunk Programming mode by pressing TRUNK. Pressing TRUNK in the Trunking mode will move to the Scan Hold mode.
50
