Uniden BCD996T manual Setting the Delay Time, Setting the Search Frequency Step, Setting Record

UB335ZH.book Page 109 Friday, March 17, 2006 4:35 PM

Setting the Delay Time

[MENU] Srch/CloCall Opt

Set Delay Time

This setting determines how long the scanner waits after a transmission ends before resuming Quick Search or Close Call operation.

1-5 sec — The scanner waits the set amount of time after the transmission ends before resuming. The default setting is 2 sec.

Off — The scanner resumes immediately when the transmission ends.

Setting the Search Frequency Step

[MENU] Srch/CloCall Opt

Set Step

This setting lets you select the frequency step used for setting the channels.

Auto — The step is based on the band (see the table at the front of the manual). This is also the default setting.

5.0kHz, 6.25kHz,

7.5kHz,8.33kHz,

10.0	kHz, 12.5		kHz,	The scanner uses the selected step.
15.0	kHz,	20.0	kHz,
25.0	kHz,	50.0	kHz,

100.0 kHz

Setting Record

You can set the RECORD OUTPUT jack to provide an audio signal to a sound recording device (tape, PC, flash memory) for live recording of transmissions.

[MENU] Srch/CloCall Opt

Set Record

On — enables an output to an audio recorder at the RECORD OUT jack.

Off — disables an audio signal at the output jack.

Adjust P25 Level

You can select the best threshold for the APCO mode.

Search and Close Call Options

109