Uniden BCD996T manual Adjusting the Key Beep, Setting the Audio AGC, Setting the Backlight Color

UB335ZH.book Page 56 Friday, March 17, 2006 4:35 PM

-Polarity — If the headlight wire is connected to vehicle ground when the headlights are on, pick this setting.

Manual — Use this setting to manually set the dimmer level to High, Middle, Low, or Off. To guide you in your selection, at each setting the display shows what you can expect to see.

Setting the Backlight Color

[MENU] Settings

Set Backlight

Set Color

Set this option to either Red or Green.

Adjusting the Key Beep

[MENU] Settings

Adjust Key Beep

Auto — the scanner automatically sets the key beep to match the master volume setting level you select.

Level 1 - 15 — the scanner lets you manually select one of fifteen key beep levels. As you turn the Scroll Control, the beep gets louder. Press when you reach the desired level.

Off — the scanner turns the key beep off.

Setting the Audio AGC

[MENU] Settings

Set Audio AGC

This setting helps balance the audio level you hear as you listen to different radio sources so you can hear them at a similar volume. Use this setting if you listen to an audio source that has natural changes in audio level for which you want to compensate.

You can set the Analog or the Digital mode to be on or off.

Analog to select either on or off specifically for receiving analog channels.

On — Press to select.

Off — Press to select.

56