Uniden DECT4096 Series, DECT 4096 manual Handling Liquid Damage, Registration Failed, Handset Base

3.In about 30 seconds, the handset display should say Registration Complete. Press Talk/flash and make sure you get a dial tone.

If...	Try...
- you don't hear a dial tone	Making sure the handset is fully
- the display says
	charged, then start over at step 1.
Registration Failed

To register a handset to a different base, see the section "Expanding Your Phone" in the user's guide for the other base.

Handling Liquid Damage

Moisture and liquid can damage your cordless phone.

If the handset or base is exposed to moisture or liquid, but only the exterior plastic housing is affected, wipe off the liquid, and use as normal.

If moisture or liquid has entered the plastic housing (i.e. liquid can be heard in the phone or liquid has entered the handset battery compartment or vent openings on the base), follow these steps:

Handset		Base
1.	Remove the battery cover and disconnect the	1.	Disconnect the AC
	battery.		adapter to cut off the
			power.
2.	Let dry for at least 3 days with the battery
		2.	Disconnect the
	disconnected and the cover off for ventilation.
3.	After the handset dries, reconnect the battery		telephone cord.
		3.	Let dry for at least
	pack and replace the cover. Recharge the
			3 days before
	battery fully (15-20 hours) before using.
			reconnecting.

IMPORTANT: You must unplug the telephone line while recharging the battery pack to avoid charge interruption.

CAUTION! DO NOT use a microwave oven to speed up the drying process. This will cause permanent damage to the handset, base and the microwave oven.

45