Charging the Battery Pack | Uniden UBC 245XLT instruction

Charging the Battery Pack

Use the AC Adapter/Charger to power the UBC 245XLT from an AC outlet.

Use only the supplied AC Adapter

(AAD-245U)

You can use your scanner while the battery charges. To fully charge the battery, leave the AC Adapter/Charger connected for 14 — 16 hours.

Note: Disconnect the AC Adapter/Charger from the unit when charging is complete.

Low Battery Indicator

When the Battery Pack is low and needs to be charged, the battery icon appears in the display. You will also hear a beep every 15 seconds as an audible alert.

12

Image 16

Uniden UBC 245XLT manual Charging the Battery Pack, Low Battery Indicator

Contents

Page Precautions Earphone Warning Front View ATT Top View and Display Contents Page Introduction Frequency Range Steps Transmission Important Notice What is Searching? Terminology What is Scanning?What is Trunk Tracking? Page Feature Highlights Manual Channel Access Go directly to any channelPage Where to Obtain More Information Information on the Internet Included with Your Scanner AC Adapter Earphone Setup Installing the Battery Pack Charging the Battery Pack Low Battery Indicator Flexible Antenna Belt Clip Basic Operation Setting the SquelchTurn the Scanner On LCD Back Light KeylockAuto Light Programming UHF CB CH4 Enter the frequency Enter the frequency number Then press Duplicate Frequency Alert Programmingn Tips Deleting a Stored Frequency Scanning CHANNELS1 2 3 4 5 6 7 8 9 RF Attenuation Feature To directly access a specific channel Setting the Delay Mode Delay in Scan or Search Mode Lockout in Manual Mode Delay in Manual ModeChannel Lockout Lockout in Scanning Mode LockoutnTips Restore a Locked Out Channel Restore All Locked-Out Channels Priority Scan Changing the Priority Channel Searching Setting a Search RangeTurbo Search Search Hold Feature Data Skip Frequency Skip Storing Search FrequenciesPage SVC Scanning UHF CB To cancel the lockout SVC Scan Lockout Programming with SVC Scan Trunk Tracking Types of Trunking SystemsPage Edacs Tracking UBC 245XLT Programming Trunking Frequencies You will hear two Frequency, press twice, and start over Changing the Display Mode Searching a Trunked Bank Frequencyn Find Mode Direct Entry ID Hold Mode Restore a Single ID ID Lockout ID DelaynMode Restore all IDsSearching Tips HoldnMode Channel Activity IndicatorsID MonitornMode Then the indicators represent multiple channels Scan Lists Programming ID Scan Lists Manually Press twice, and start over Xpand Page ID Scan Mode Setting Priority in Trunking Mode Programming Scan Lists During Search Deleting a Stored ID Moving between Scan List Memories Multi-Track Selecting Trunking Programming Mode Fleet Map Programming Selecting a Preset Fleet Map If you are in Trunking Scan mode Scanner returns to Programming Bank selecting mode Programming a Fleet Map Programming a Hybrid System Page Toggling the Status Bit Remote Interface Connecting the scannerScanner to PC Scanner to External Modem Scanner to Scanner SmartScan Mode US Only Page Program Lock US Only Menu for SmartScan Smartscanner Tips US Only Page Remote PC Control Mode Start Remote Mode PC Control Parameter Change Transfer Speed Clone Mode Page Care and Maintenance CleaningGeneral Use Location Repairsn Birdies Troubleshooting Problem Suggestion Try another Preset Fleet Map or Program Specification Above bands in 5 kHz steps Preset Fleet Maps Appendix Preset Map E1P9 Block User Defined Fleet Maps Type I Programming Information Fleet Map Size Codes Size Code Restrictions Page One Year Limited Warranty Uniden UBC245XLT UBZZ01311AZ