ConfigurationTank Gauge Transmitter
3.4.2 | Summary Menu |
|
|
Summary Menu | Description |
Level | Current level. |
|
|
Temperature | Current temperature |
|
|
RTD Resistance | RTD resistance measured |
|
|
Cfg Error Type | Configuration error type detected. |
|
|
Power Log | Number of times unit has gone through a power down cycle |
| since it was last configured. Going into Alter Mode and using |
| 'Exit and Save' resets this value to 0. |
|
|
Bad CPU Board Stat3 | Bad CPU Board Stat3True if the RAM, ROM, or EEPROM are bad. |
|
|
Bad RAM Stat3 | True if RAM status is bad. |
|
|
Bad EProm Stat3 | True if EProm status is bad. |
|
|
Bad EEProm Stat3 | True if EEProm status is bad. |
|
|
Bad EECksum Stat3 | True if EEProm checksum does not match the data stored in it. |
|
|
Bad Comm Board3 | True if communication board failed loopback test |
|
|
Bad Level Stat3 | True if level is bad. |
Bad Temp Stat3 | True if temperature input is out of range. |
Low Battery Stat3 | True if battery voltage is low or no battery is connected. |
Crit Hi Level Stat3 | True if the level is above the critical high level setpoint |
Adv Hi Level Stat3 | True if the level is above the advisory high level setpoint |
Adv Lo Level Stat3 | True if the level is below the advisory low level setpoint |
Crit Lo Level Stat3 | True if the level is below the critical low level setpoint |
Crit Hi Temp Stat3 | True if the temperature is above the critical high temperature |
| setpoint |
|
|
Adv Hi Temp Stat3 | True if the temperature is above the advisory high temperature |
| setpoint |
|
|
Adv Lo Temp Stat3 | True if the temperature is below the advisory low temperature |
| setpoint |
|
|
Crit Lo Temp Stat3 | True if the temperature is below the critical low temperature |
| setpoint |
|
|
16 | Installation and Operations Manual |
