ICA-500 Users Manual

Appendix A: Restore Factory Default Settings

There is a button hidden in the pinhole above the Alarm I/O connector. It is used to restore the factory default settings. Sometimes restarting the ICA-500 will make the system back to a normal state. If the system still got problems after reset, user can restore the factory default settings and install it again.

Restore the ICA-500:

1.Power off the ICA-500.

2.Insert the paper clip or other tool and press and hold the button down continuously.

3.Power on the ICA-500 again.

4.Wait at least 8 seconds and release the tool. Then the ICA-500 has been restored to default settings.

Note: Restoring the factory default setting will lose the all-previous settings forever. User needs to run the IP Finder program to search the ICA-500 and configure it to let the ICA-500 work properly again.

62/80