2. Vertical vane
(1) Vane motor drive
These models are equipped with a stepping motor for the vertical vane. The rotating direction, speed, and angle of the motor are controlled by pulse signals (approx. 12 V) transmitted from microprocessor.
(2) The vertical vane angle and mode change as follows by pressing WIDE VANE button.
1
2 
3
4 
SWING 
5
6 
(3)Positioning
The vane is once pressed to the vane stopper to confirm the standard position and then set to the desired angle. Confirming of standard position is performed in the following cases.
(a)OPERATE/STOP (ON/OFF) button is pressed (POWER ON/OFF).
(b)SWING is started or finished.
(c)The power supply turns ON.
(4)SWING MODE ( 
)
By selecting SWING mode with WIDE VANE button, the vertical vane swings horizontally. The remote controller displays “
”.
(5)WIDE MODE ( 
)
By selecting WIDE mode with WIDE VANE button, indoor fan speed becomes faster than setting fan speed on the remote controller (
). The remote controller displays “
”.
NOTE : The position of vane angle 3, angle 4 and angle 5 are different in COOL operation and HEAT operation.
Indoor fan speed becomes faster than setting fan speed on the remote controller even when 
or 
is select- ed.
16
