The Pinnacle (PDV20) and Stardance (SDVR) Direct | WARNING: Operation of this heater when not con- |
Vent Room Heater, Model Nos. 3920, 3926, 3930, 3936, | nected to a properly installed and maintained venting |
3960, 3966, 3970, 3976, 4065, 4070, 4075, 4080, are | system can result in carbon monoxide (CO) poison- |
vented gas appliance listed to ANSI Standard Z21.88b- | ing and possible death. |
2002 and CSA-2.33b-2002 for Vented Room Heaters, and | The PDV20 and SDVR Direct Vent Room Heater, when |
CSA 2.17-M91, Gas-Fired Appliances For Use at High Al- | installed, must be electrically grounded in accordance with |
titudes. | local codes or, in the absence of local codes, with the Na- |
The installation of the PDV20 and SDVR Direct Vent | tional Electrical Code ANSI/NFPA 70, (latest edition), or of |
Room Heaters must conform with local codes, or in the | the current Canadian Electrical Code C22.1. |
absence of local codes, with National Fuel Gas Code, ANSI | Due to high temperatures this appliance should be |
Z223.1/NFPA 54 — latest edition and CSA B-149.1 (EX- | located out of traffic and away from furniture and |
CEPTION: Do not derate this appliance for altitude. Main- | draperies. |
tain the manifold pressure at 3.5” w.c. for Natural Gas and | WARNING: This appliance is hot while in operation. |
10” w.c. for LP gas at maximum input.) Refer to Page 37 | Keep children, clothing, and furniture away. Contact |
(RF only). | may cause burns or ignition of combustible materials. |
This appliance is only for use with the type of gas indi- | Children and adults should be alerted to the hazards |
cated on the rating plate. This appliance is not convertible | of high surface temperatures and should stay away to |
for use with other gases unless a certified kit is used. | avoid burns or clothing ignition. Young children should |
Installation and replacement of gas piping, gas | be carefully supervised when they are in the same |
utilization equipment or accessories, and repair and | room as the appliance. |
servicing of equipment shall be performed only by a | Clothing or other flammable materials should not be |
qualified agency. The term “qualified agency” means | placed on or near the appliance. |
any individual, firm, corporation, or company that either | Any safety screen, glass or guard removed for |
in person or through a representative is engaged in | servicing an appliance must be replaced prior to |
and is responsible for (a) installation or replacement of | operating the appliance. |
gas piping, or (b), the connection, installation, repair, | The appliance area must be kept clear and free from |
or servicing of equipment, who is experienced in such | combustible materials, gasoline, and other flammable |
work, familiar with all precautions required, and has | vapors and liquids. |
complied with all the requirements of the authority | The flow of combustion and ventilation air must not |
having jurisdiction. | be obstructed. The installation must include adequate |
The PDV20 and SDVR Direct Vent Room Heaters | accessibility and clearance for servicing and proper |
should be inspected before use and at least annually | operation. |
by a qualified service agency. It is imperative that | WARNING: Do not operate the Room Heater with the |
control compartments, burners, and circulating air | glass panel removed, cracked or broken. Replacement |
passageways of the appliance be kept clean. | of the panel should be done by a licensed or qualified |
The PDV20 and SDVR Direct Vent Room Heaters and | service person. |
the individual shut-off valve must be disconnected from | Do not use this appliance if any part has been under |
the gas supply piping during any pressure testing of that | water. Immediately call a qualified service technician |
system at test pressures in excess of 1/2 psig (3.5 kPa). | to inspect the appliance and to replace any part of the |
The PDV20 and SDVR Direct Vent Room Heaters must | control system and any gas control which has been |
be isolated from the gas supply piping system by closing | under water. |
the individual manual shutoff valve during any pressure | Do not burn wood, trash or any other material for |
testing of the gas supply piping system at test pressures | which this appliance was not designed. This appliance |
equal to or less than 1/2 psig. | is designed to burn either natural gas or propane only. |
An accessible tap is located above the pilot/on-off knob | This gas appliance must not be connected to a |
for checking the inlet pressure. | chimney flue serving a separate solid-fuel burning |
'Direct Vent' describes a sealed combustion system in appliance. |
which incoming outside air for combustion and outgoing | CAUTION: Label all wires prior to disconnection |
exhaust enter and exit through two separate concentric | when servicing controls. Wiring errors can cause |
passages within the same sealed vent system. The sys- | improper and dangerous operation. |
tem does not use room air to support combustion. The | Verify proper operation after servicing. |
Direct Vent system permits the gas appliance to be vented | Proposition 65 Warning: Fuels used in gas, |
directly to the outside atmosphere through the side of the | woodburning or oil fired appliances, and the products of |
house or vertically through the roof. | combustion of such fuels, contain chemicals known to the |
This appliance is approved for bedroom installations in | State of California to cause cancer, birth defects and other |
the U.S. and Canada. | reproductive harm. |
This appliance may be installed in an aftermarket* | California Health & Safety Code Sec. 25249.6 |
manufactured (mobile) home, where not prohibited by state | * Aftermarket: Completion of sale, nor for purpose of resale, |
or local codes. | from the manufacturer. |
