| Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters | |||
Auto Path |
|
|
|
|
If the manual switch is |
|
|
|
|
set to REMOTE, | Move switch from |
|
|
|
press the mode button | IH O |
| OFF | |
to display AUTO on the | LOCAL to REMOTE. |
| NO | PILOT ADJ |
transmitter. Does the | Press any key within |
|
|
|
transmitter display the | 30 seconds. |
|
| Main |
room and temperture |
|
|
| Gas Line |
setting? |
| Gas Supply Inlet | ||
|
|
| ST226 | |
|
|
|
| |
Yes |
| Fig. 56 Attach the gas line to the right side of the valve. | ||
|
|
|
| |
If the settings is above |
|
|
|
| |
|
| Conversion Precautions |
| ||
room temperture on the | No |
|
|
| |
transmitter, does the |
|
| Before proceeding, turn control knob on valve to OFF |
| |
|
|
|
| ||
|
|
| |||
main valve and fan |
|
| and turn gas supply OFF. Turn OFF any electricity that |
| |
turn on? |
|
| may be going to the appliance. |
| |
| Yes |
|
|
| Conversion Procedure | |||
|
|
|
|
| 1. | Remove stove front. Lift stove front up and then | ||
| If the settings is below | |||||||
|
|
|
| swing bottom out and away to disengage from the | ||||
| room temperture on the | No | ||||||
| stove body. (Page 36, Fig. 65) | |||||||
| transmitter, does the |
|
|
|
| |||
|
|
|
|
| ||||
| main valve and fan | 2. | Swing open the swiveling latches at the top left and | |||||
| turn off? |
|
|
| right corners of the glass frame. (Page 37, Fig. 66) | |||
|
|
|
|
| 3. | Pull the top edge of the glass and frame assembly | ||
|
|
|
|
|
|
|
| away from the firebox face. Place the assembly out of |
|
|
|
|
|
|
|
| |
| Turn pilotstat knob to |
|
|
| the way on a flat, padded surface such as a counter | |||
| OFF to turn valve |
|
|
| protected by a towel. | |||
| completely off. | 4. | Remove the logset from the firebox. | |||||
|
|
|
|
| 5. | Remove the rear log bracket by unfastening the | ||
|
|
|
|
| ||||
|
|
|
|
|
|
|
| screw. (Fig. 57) |
Fuel Conversion Instructions
WARNING! This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all appli- cable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the manufacturer’s instructions supplied with the kit.
CAUTION: The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding with the conversion.
6.Remove the right and left log bracket assembly by unfastening the two screws which hold the burner in place. (Fig. 57)
Remove Screws | Rear Log Bracket | |
|
| Pilot |
| Left & Right Log |
|
| Bracket Assembly | ST350 |
Fig. 57 Remove rear log bracket and left and right log bracket assembly.
20007066 | 33 |
