Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
Switch | Existing | |
Assembly | ||
Holes | ||
| ||
Screws | ST315 | |
| ||
Fig. 40 Attach switch assembly to rear shroud. |
|
TPTH
TPTH
PILOTADJ
ST228
Thermostat Connection
(Optional) R Models Only
Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge thermostat wire to use for the length of lead required in your installation.
Thermostat |
|
Wire / Gauge | Maximum Run |
18 | 40 feet |
20 | 25 feet |
22 | 16 feet |
1.Install the wall thermostat in the desired location and run the wires to the stove location. Terminate these leads with 1/4” female connectors.
2.Connect the thermostat wires to the valve. (Fig. 41)
This completes assembly of the PDV20 and SDVR stove.
Fig. 41 Attach switch wires to valve.
Install the Front Plate
Grasp the Front Plate and lift it into position, engaging the two steel tabs at the upper corners behind the adjacent bosses in the Side Plates. (Fig. 42) Seat the Front against the Sides so that the tabs at the bottom lip engage with the notches in the edge of the stove base.
When properly installed, the bottom of the Front Plate cannot be pulled away from the sides without also lifting it up.
If you are installing optional Warming Shelves, do so now, according to the instructions supplied with that kit.
Bottom Tabs |
|
Engage Notch in Base | ST407 |
|
Fig. 42 Install Stove Front.
24 | 20007066 |