Vermont Casting 3970, SDVR Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters, 20007066

Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters

6.Apply high-temperature sealant to the top of the chimney. Feed the two liners down through the chimney flue and damper opening. Fasten the termination assembly to the chimney with the four set screws (C) provided.

7.Trim the flex liners as needed. Each should be only long enough to connect to the Transition Connector. There should be no sag in either flex liner when the stove is in place.

8.Attach the flex liners to the Transition Connector, using high-temperature sealant and clamps as shown in Figure 35. Prop the connector in rough position until the heater is in place in front of it.

Fireplace Vent System			B
		B
		A	B
			D
B	C
C
B			C
A = Sealant Locations
	A
B = Sheet Metal Screws			B
C = Termination Screws	D		A
D = Clamps

	A
	B
A	D
	A
	D

B ST395

Fig. 35 Fireplace vent system installation.

20 20007066