Installation
Vidikron Vision 85 Owner’s Operating Manual 17
PRELIMINARY
3.2 Quick Setup

Table 3-1 gives a quick overview of the Vision 85 installation process. The sections following

this one provide detailed instructions.

Installation should be performed by a qualified custom video installation

specialist.

Table 3-1. Installation Overview

Step Procedure For Details, Refer to
page...
1Choose a location for the projector 18
2
If installing a Vision 85/CineWide or Vision 85/CineWide
with AutoScope: Install fixed CineWide base plate or
AutoScope lens motor (optional)
23
3Mount the projector 27
4Connect the VHD Controller to the projector 28
5Connect signal sources to the VHD Controller 29
6Connect external controller to RS-232 port (optional) 33
7Connect other home theater components to 12-volt trigger
outputs (optional)
34
8Connect the projector, VHD Controller and AutoScope lens
motor (if present) to power and turn on the system
36
9For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
37
10 Primary lens adjustments: projected image size (zoom),
position (shift) and focus
20, 37
11 Install CineWide anamorphic lens (optional) 38
12 CineWide lens adjustments: position, pitch (angle), geometry
and focus
39
13
Projector calibration – Analog 1080i and
lower-resolution signals:
Adjust the following for Component SD input; save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
49 through 62
14 Repeat Step 13 for S-Video 1, S-Video 2, Composite Video,
HD1 and HD2 inputs
Note