Vidikron Model 85 manual volt Trigger Output Connection from Projector

Installation

Projector: The projector is equipped with an additional 12-volt trigger output. This trigger activates when the projector is turned on. Connect it to your retractable screen or other, 12-volt trigger-activated equipment as shown in Figure 3-17.

RETURN	ENTER	DOWN	UP	LEFT	RIGHT		MENU	RATIO	STANDBY	ON
								ASPECT
RETURN	ENTER	DOWN	UP	LEFT	RIGHT		MENU	ASPECT	STANDBY	ON
								RATIO
HDMI
HDMI
60Hz-50 240V-100 IN AC				TRIGGER		IR	OUT 232-RS
				TRIGGER		IR	RS-232 OUT

(cylindrical,

AC IN 100-240V 50-60HzDC power

supply-type plug)

to retractable screen
or other, 12-volt	Sleeve = Ground
trigger-activated
	Tip = +12V
equipment

Figure 3-17. 12-volt Trigger Output Connection (from Projector)

If infrared signals from the remote control cannot reach the VHD Controller due to excessive distance or obstructions such as walls or cabinet doors, you can connect an external IR receiver to the VHD Controller to extend the range of the remote control. See Figure 3-18.

VHD Controller Rear Panel

SYSTEM CONTROL INTERFACE	CAUTION	!
	RISK OF ELECTRIC SHOCK
	DO NOT OPEN
	AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

TRIGGERS

CAUTION: TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE COVER. NO USER-

SERVICEABLE PARTS INSIDE. REFER SERVICING

TO QUALIFIED SERVICE CENTER.

1 2 3 IR

WARNING: TO REDUCE THE RISK OF FIRE

OR ELECTRIC SHOCK, DO NOT EXPOSE

THIS APPLIANCE TO RAIN OR MOISTURE.

S-Video 1

100-230VAC 50-60 Hz, 165 Watts Max

Video S-Video 2 RS-232 Out RS-232 Control Made In USA

Ring = +5V

IR ReceiverTip = IR Input

Sleeve = Ground

Remote	(3.5-mm
Control
	mini phono
	plug)

Figure 3-18. External IR Receiver Connection

When an external IR receiver is connected to the wired IR input, the

Note built-in IR sensor on the VHD Controller is disabled.

Connecting an External IR Receiver to the VHD Controller

Vidikron Vision 85 Owner’s Operating Manual 35