Vidikron Vision 120 operation manual Issue LED

Controls and Functions

6.RIGHT BUTTON

Used to direct-select inputs or move the menu cursor right in the OSD. When no menu is present on-screen, the RIGHT button toggles through the different sources, in this order: Composite (VID) - S-Video - HD 1 (RCA) - HD 2 (BNC) - HD 3 (VGA/Y-Pb-Pr) - HDMI 1 - HDMI 2

7.MENU BUTTON

Pressing the MENU button brings up the main menu. Also, if you are in an adjustment mode or function, pressing MENU brings the menu back one level.

8. RUN LED

–Lights blue to indicate that the projector is functioning normally.

–Flashes blue (one second on/one second off) to indicate an error condition.

–Flashes blue (one half-second on/one half-second off) for approximately 90 seconds after the system is turned off.

9.ISSUE LED

Lights red to indicate an error condition.

10.UP BUTTON

Use to direct-select aspect ratios or move the menu cursor up in the OSD. When no menu is present on-screen, the UP button toggles through aspect ratios in the following order:

16:9 - 4:3 - Letterbox - IntelliWide - Cinema - IntelliWide 2.35

(IntelliWide 2.35 is available only on CineWide-equipped projectors. For more information about aspect ratios, refer to Table 4-1.)

11.SELECT BUTTON

Press SELECT to confirm your selection of a highlighted choice on the OSD.

12.STAND-BY LED

Lights orange to indicate that the projector is in standby mode.

13.SOFT POWER BUTTON

Press once to turn on the Vision 120. Press it again to put the projector into Standby mode. For a discrete on or off command, you can use the direct access buttons on the remote control (see Figure 2-5).

Vidikron Vision Model 120 Installation/Operation Manual 9