Installation
Connecting to AC Power ➤ Projector/VHD Controller: Plug the female end of one power cord into the AC receptacle on the rear of the Vision 120 (AC 100V ~ 240V). Then, connect the other end to your AC power source.
Similarly connect the VHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With
Caution | The input voltage to the AutoScope lens motor must be between 100 and |
120 VAC. Do not connect the AutoScope lens motor to a | |
| power source! |
3.8
Turning on the Power
1.Turn on your source components.
2.Turn on the main power switch at the rear of the VHD Controller.
3.If this is an
4.Press the ON button on the remote control – or the SOFT PWR button on the VHD Controller front panel – to turn on the system. The vacuum fluorescent display on the VHD Controller front panel briefly displays “Starting Display.”
5.When the projector is ready for use (after about 20 seconds), the RUN LED on the VHD Controller front panel lights solid blue. The fluorescent display indicates the current input source, aspect ratio and input resolution; for example:
Current Input Source
3.9
Adjusting the Picture Orientation
| V120 |
| Component RCA | ||||
16:9 |
|
| 480I | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Aspect Ratio | Input Resolution | ||||||
By default, the Vision 120 is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen and/or inverted, you must change the picture orientation. To do this:
1.Press MENU.
2.Select Service from the Main Menu and enter the Service Menu passcode.
3.Select Display Device from the Service Menu.
4.Select Installation from the Display Device menu.
5.Choose Floor Rear, Ceiling Front or Ceiling Rear, to match the installation method.
40 | Vidikron Vision Model 120 Installation/Operation Manual |
