Installation

3.11

Installing and Adjusting the CineWide Anamorphic Lens

If you are installing a CineWide-equipped projector, proceed as follows to install and adjust the anamorphic lens.

It is extremely important that the primary lens is properly adjusted

Note before you install the anamorphic lens. Ensure that the image from

the primary lens is perfectly centered on the screen.

Attach Lens Mounting

The Vision 120 Anamorphic lens mount kit consists of everything shown in Figure 3-19.Some

Assembly to Lens Motor

components shipped with your projector may differ slightly from what is shown in these

Carriage Plate (CineWide

instructions. If any items are missing or damaged, please contact your Vidikron dealer or

with AutoScope) or Base

Vidikron Customer Service at (888) 4VIDIKRON.

Plate (fixed CineWide)

 

1 Lens Adapter Ring and

Mounting Screws (3x)

10 Anamorphic Lens

Set Screw

9 Pitch Adjustment

T-Nut (2x)

2 Pitch Adjustment Yoke for Lens

3 Height/Y Adjustment

T-Screw and Washer

(2x)

4 Pitch Adjustment

T-Screw and

Washer (2x)

5 Anamorphic Lens

Holder

8 Yaw/X Adjustment

Lever (2x)

6 1/4-20 Hex Bolt (2x)

and Washer (2x)

7 AutoScope Carriage Plate or Fixed CineWide Base Plate

Figure 3-19. Vision 120 Anamorphic Lens Mounting Assembly - Exploded View

1.Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the Anamorphic Lens Holder (item #5).

2.Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or fixed CineWide Base Plate (item #7). Position the bracket so that the long slot at the bottom of the lens holder is perpendicular to the corresponding slots on the plate.

42

Vidikron Vision Model 120 Installation/Operation Manual

Page 56
Image 56
Vidikron Vision 120 operation manual Installing and Adjusting the CineWide Anamorphic Lens, Plate fixed CineWide