Viking DMOD241 Information You Need To Know, About Unpacking and Examining Your DrawerMicro Oven

Information You Need To Know

About Unpacking and Examining Your DrawerMicro Oven

1.Remove all packing materials from inside the DrawerMicro Oven. DO NOT RE- MOVE THE WAVEGUIDE COVER, which is located on the top of the DrawerMicro Oven.

2.Remove the feature sticker, if there is one. Check the drawer for any damage, such as misaligned or bent drawer, dam- aged drawer seals and sealing surfaces, broken or loose drawer guides and dents inside the cavity or on the front side of the drawer. If there is any damage, do not op- erate the DrawerMicro Oven and contact your dealer or a Viking AUTHORIZED SERVICER.

Sealing

Surface

Waveguide

Cover

Sealing

Surface

Oven

Cavity

RADIO OR TV INTERFERENCE

Should there be any interference caused by the DrawerMicro Oven to your radio or TV, check that the DrawerMicro Oven is on a different electrical circuit, relocate the radio or TV as far away from the drawer as feasible or check position and signal of receiving antenna.

ABOUT your DrawerMicro Oven

ALWAYS have food in the DrawerMicro Oven when it is on to absorb the microwave energy.

The vent under the DrawerMicro Oven must not be blocked. During micro- waving, steam may come from the right side of the vent.

When using the DrawerMicro Oven at power levels below 100%, you may hear the magnetron cycling on and off. It is normal for the exterior of the DrawerMicro Oven to be warm to the touch when cooking or reheating.

Condensation is a normal part of microwave cooking. Room humidity and the moisture in food will influence the amount of moisture that condenses in the DrawerMicro Oven. Generally, covered foods will not cause as much condensation as uncovered ones.

The DrawerMicro Oven is for food preparation only. It should not be used to dry clothes or newspapers.

Your DrawerMicro Oven is rated 950 watts by using the IEC Test Procedure.

E