VTech DS6121-4 user manual Set remote access code, Set message alert tone

Answering system

Set remote access code

A two-digit security code is required to access the answering system remotely from any touch tone telephone. The preset code is 19. You can set the code from 10 to 99.

To set the remote access code:

1.Press SETUP when the telephone is not in use until the system announces the remote access code setting.

2.Press /SKIP or /REPEAT to change the remote access code by one, or press and hold /SKIP or /REPEAT to change it by increments of ten. Press SETUP to save the setting and go to the next setting, or press /PLAY/STOP to save and exit setup mode.

Set message alert tone

This feature programs the system to beep every 10 seconds to alert you of new messages. The tone will stop when all new messages have been reviewed.

To set the message alert tone:

1.Press SETUP when the telephone is not in use until the system announces the message alert tone setting.

2.Press /SKIP or /REPEAT to select on or off, then press SETUP to save the setting and go to the next setting, or press /PLAY/STOP to save and exit setup mode.

•The answering system must be turned on for the message alert tone to function.

Basic operationAnswering system

www.vtechphones.com 39