Wacom 20WSX, DTZ-2000W Adjusting the LCD monitor, Factory presets, auto-sync, and user settings

Adjusting the LCD monitor

Factory presets, auto-sync, and user settings

Factory presets: For optimal display quality, set your video card to Cintiq’s native resolution of 1680 x 1050 pixels (WSXGA). See page 62 for signal specifications.

Auto-sync:When connected as a VGA display, Cintiq attempts to automatically synchronize to the incoming signal. At the native resolution of 1680 x 1050, the vertical refresh frequency must be set to 60 Hz. For other resolutions, auto-sync will function when the horizontal frequency is between 30 to 82 kHz and the vertical frequency is between 50 to 75 Hz. If a specific resolution and vertical refresh frequency are not supported, you will see an “out of scan range” message. In this case choose a different resolution or refresh frequency. The auto-sync function automatically sets the horizontal and vertical screen position, as well as pitch and phase.

If Cintiq does not automatically synchronize with the incoming signal, you can open the OSD menu, go to the RESET menu, and select the AUTO ADJUST option to initiate display synchronization. Additional screen display adjustments can be manually made using the OSD controls.

Color calibration: Changing the color, color temperature, contrast, brightness, or backlight from their default settings will invalidate the ICC color profile that was included on the driver CD.

Working with on screen display settings

Cintiq is equipped with an On Screen Display (OSD) function. The OSD function enables you to adjust and optimize a variety of display settings at the touch of a button. The OSD controls are located on the back of the unit. Simply reach over the top of the display unit to locate the buttons with your fingers.

Note: Braille-style dots above the buttons help you to identify each one by touch.

Digital/Analog (DVI/VGA) switch

(up) (down) MENU button

Selection buttons

Use these buttons to select an option that can then be activated when you press the ENTER button.

After activating a selected option, press the up button to increase a selected item value, and press the down button to decrease it.

Use this button to open or close the OSD menu.

ENTER button

Activates or deactivates the selected OSD menu option.

Customizing Page 36