Using an alternate mount or stand
Cintiq can be attached to any mount arm or stand conforming to the VESA 100 standard.
Mounting screws that are 4 mm wide with a
0.7mm pitch (M4 Regular), with a screw clearance depth from 13 – 18 mm are required.
To attach Cintiq to a VESA 100 mounting platform:
1.Turn off your computer and power off Cintiq. Then disconnect all cables from
between the unit and your computer.
2.Remove Cintiq from its stand and place it face down on a flat, soft surface (such as a cloth spread across a desktop).
3.Remove the bearing hub by unscrewing the four bearing hub attachment screws. Then carefully separate the bearing halves and remove the bearing stopper to free up the cabling. Take care not to lose the small bearing stopper found within the inner groove of one of the hub sections.
Cable channel
Bearing hub sections (removed)
Attachment screws
Bearing stopper
Cable cover plate (removed)
Attachment screws
Appendix
Page 57
