Aluminum Full View | Wayne-Dalton 8850 instruction

8850 Aluminum Full View

Torsion Spring

Installation Instructions and Owner’s Manual

Wayne-Dalton Corp. P.O. Box 67

Mt. Hope, OH 44660 www.wayne-dalton.com

IMPORTANT NOTICE!

Read these instructions carefully before attempting installation. If in question about any of the procedures, do not perform the work. Instead, have a qualified door agency do the installation or repairs.

Part No. 348366

REV1 08/03/2009

Page 1

Image 1

Wayne-Dalton 8850 installation instructions Aluminum Full View

Contents

Aluminum Full View Table of Contents Package Contents Door Section Identification Package Contents P1 Removing An Old Door Tools Required Securely attach a Preparing the OpeningFailure to Suitable mounting pad to structurally Consult your Wayne-Dalton representative Tools Needed Installation To Bottom Brackets Bottom Section Hinges Installing Bottom Section Section Inch track Stacking Sections Lift Handle Top Bracket Top Section Step Plate Flagangle Adjusting Top Brackets Center Bearing Bracket Torsion End Bearing Brackets Torsion Spring Assembly Attaching Torsion Springs to Center Bearing Bracket Securing Door Counterbalance CablesFor Spring Winding Winding Torsion Springs Keep horizontal track Rear SupportParallel and within 3/4 Maximum of door edge Otherwise door could fall Third roller. Insert a winding bar into Tools Needed To adjust spring tension, fully closeSet screws in the winding cone Agency Pull Rope Side Lock Trolley Operator Or a double wide bottom rail Exhaust Port InstallationBoth sides of the door section Outside Trim Ring #10 Hex Nuts Gasket Cleaning Your Garage Door Cleaning Limited Warranty Model Thank you for your purchase