Wayne-Dalton 9300 in cable coming off the pin and, The Building Looking Out, Left hand, carrier

5	Drums
	IMPORTANT: RIGHT AND LEFT HAND
Tools Needed:
	IS ALWAYS DETERMINED FROM INSIDE
None	THE BUILDING LOOKING OUT.
	NOTE: For door section identification see page 4.
	TorqueMaster® drums are marked right and left
	hand. Uncoil the counterbalance cables and make
	sure you place the right hand cable loop on the
	right hand milford pin and place the left hand
	cable loop on the left hand milford pin. Check to
	ensure the cable loop fits tightly over the milford
	pin.
	WARNING
	Failure to ensure tight fit of cable
	loop over milford pin could result
	in cable coming off the pin and
	allowing door to fall, possibly
	resulting in severe or fatal injury.
	Bottom section: Insert roller into bottom roller
	carrier hole and insert another roller into the inner
	roller carrier hole, located at the top of the bottom
	section.
	Lock section: Insert roller into the inner roller
	carrier hole.
	Intermediate section I: Insert roller into the
	outer roller carrier hole.
	Intermediate section II (5 section- 8’ Height
	only): Insert roller into the Outer roller carrier hole.

	Left hand
	counterbalance drum
	Top roller
	carrier
	Inner roller	Bottom Section
	carrier hole
Rollers
Milford pin
	Bottom roller
	carrier hole
	Outer roller
	carrier hole
	Inner roller
	carrier hole
	Lock and Intermediate Sections
MILFORD
PIN	BOTTOM
	SECTION
ASTRAGAL

10

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com