15 | Center Bracket Assembly | |
| ||
|
| |
Tools Needed: | NOTE: If you are installing the idrive® opener with | |
None | your garage door, skip this step and go to your | |
idrive® Installation Instructions and Owner’s Manual. | ||
| ||
| After completing steps | |
| Instructions and Owner’s Manual, rear supports | |
| NOTE: If you are not installing the idrive® opener on | |
| your garage door, you must install the center bracket | |
| bushing assembly. Follow these instructions for | |
| ||
| Being cam shaped the center bracket assembly only | |
| fits one way. | |
| Slide the center bracket assembly towards the center | |
| of the TorqueMaster® spring tube assembly, from the | |
| right side as shown. | |
|
|
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER®
SPRING TUBE
ASSEMBLY
TORQUEMASTER® |
SPRING TUBE |
ASSEMBLY |
CENTER
BRACKET
BUSHING
16 | Cable Drums |
| |
|
|
Tools Needed: | Shake the TorqueMaster® spring tube assembly |
| gently to extend the winding shafts out about 5" on |
Tape Measure | each side. For single spring applications, there will |
| be no left hand spring in the TorqueMaster® spring |
Step Ladder | tube assembly. |
| Lift the TorqueMaster® spring tube assembly and |
| rest it on the top of the flagangles. |
| NOTE: Cable drums are marked right and left hand |
| Cable drums and TorqueMaster® spring tube |
| assembly are cam shaped to fit together only one |
| way. |
| Starting on the right hand side, slide the drum wrap |
| over to access the counterbalance cable. Now, pre- |
| wrap the right hand cable drum with the counter |
| balance cable |
| Position the Torquemaster® spring tube assembly so |
| the cam peak is pointing straight up. Slide cable |
| drum over the winding shaft until the cable drum |
| seats against the TorqueMaster® spring tube |
| assembly. |
| The winding shaft must extend past the cable drum |
| far enough to expose the splines and the groove. |
| Align the winding shaft groove with the round notch |
| in the flagangle. |
|
|
16
| RIGHT DRUM | COUNTERBALANCE |
CAM PEAK | CABLE | |
WINDING |
| |
STRAIGHT UP |
| |
SHAFT |
| |
|
|
5”
TORQUEMASTER® SPRING
TUBE ASSEMBLY
1-1/2 Wrap Shown
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at
